Finally it has arrived! My first professionally produced PCB.

The power to drone, right in your hand! The mini Organ Dronor is a smaller version of the “Organ Dronor” analog drone system I’ve been developing over the last 2 years. Unlike most simple drone machines out there my design features a custom waveform which add a lot of interesting harmonics. For the controls it uses a single knob to set the overall frequency and a light sensor to control the relative frequency between the oscillators. This results in a very intuitive interface and allows for outside modulation using any light source.

Features
-Fully assembled and tested
-simple 9V battery operated (9v not included)
-small! just 5x5cm
-Light controlled droning
-standard 1/4″(6.35mm) output (different from the picture wich shows a 1/8″ jack)
IMG_0074IMG_0078